Did you accidentally drop your phone in the water and find out the device is not working properly? Then, you need to immediately take certain actions to prevent your phone from being dead. Most of us would visit the service center to repair the phone. But you can actually fix the phone that was dropped in water by yourself using simple troubleshooting methods. Go through this guide and learn the procedures in detail.
Steps to Fix a Phone Dropped in Water
If your phone is water-logged, make use of the steps mentioned below one by one to get rid of the water from the smartphone and dry it completely.
Turn Off the Phone
The first thing you need to do after the phone gets wet is to turn it off. Just close all the apps and power off the device. Sometimes, if your phone is exposed to excessive water, it will automatically be turned off.
Wipe the Phone with Dry Cloth
After turning off the device, the next thing to do is to wipe the phone immediately with a dry, soft cotton cloth. Wipe the phone completely by removing the back case, and make sure to remove all the water droplets you see on the phone. After doing it, keep the phone idle under the fan for 5 to 10 minutes. Do not keep the phone under direct sunlight.
Remove the Battery and SIM Card
Remove the SIM Card slot from your phone and dry it. If you have a rechargeable battery, remove it from the phone and wipe it. Then, keep the battery idle and let it dry. Remember that during the entire process of removing the water from the phone, don’t put your phone to charge.
Shake the Phone Gently
Gently shake the smartphone for 2 minutes. By shaking the phone, excessive water accumulates in the speakers, sensor, battery charging port, and SIM card slot will be drawn out. Most people often make a common mistake, which is blowing the air on the speaker. This is not recommended as the blowing pushes the water droplets inwards. The water may further penetrate into the hardware components of the phone and can cause permanent damage.
Bury the Phone in Rice
One of the effective ways to remove the water from the phone is to bury the device in a container full of rice. Make sure that the smartphone is immersed fully in the rice and kept for 8-10 hours. While burying the phone, ensure that no rice particles don’t go into the charging port or speakers. Carefully immerse the phone in the rice container.
Place the Phone in an Air-tight Container with Silicon Gels
If you are not interested in putting the phone in a rice container or if you fear that the rice particle may penetrate into the phone’s charging port, use the empty container filled with the Silica Gel packets. These Silica Gel packets have the ability to absorb the moisture from the phone and make it dry. Keep the phone in the container for a night and try using it.
Use a Smartphone Cleaning Kit
If you find any small water droplets stuck on the phone’s speakers, buy the Cleaning Kit from Amazon and use it. This kit is specially developed for smartphones, laptops, etc. These cleaning kits have several minute brushes and instruments to penetrate and clean the dust or debris from speakers, charging ports, and more. You can use these brushes to suck the water droplets out from the holes.
Eject Water from the Speakers
Another way to drain the water droplets from the speakers is to visit the website fixmyspeakers.com. This website removes the water droplets from the speakers in minutes. By selecting the water ejection button on the webpage, a calibrated tone will be produced with a specific frequency. This makes the speakers vibrate rapidly. As a result, the water droplets on the speakers will be ejected out.
Visit the Nearby Service Center
If none of the solutions work, it indicates that there is serious hardware damage. To fix it, visit the nearby service center and repair the device. In rare cases, if the hardware is damaged, it’s best to replace your phone instead of repairing it.
Give Nano Coating to Make Your Smartphone Waterproof!
It is one of the best preventive measures that make your phone water-repellant. Nano-coating is the process where a thin layer of water-repellant nanoparticles is applied to the phone’s surface and holes. By adding this coating to your phone, you can protect the device even from dust and debris. The cost of nanocoating is also affordable, and it stays for a lifetime once applied on the phone.
Frequently Asked Questions
To remove the water inside the phone screen, dry it by keeping it in a container full of silica gel packets or rice. If the water didn’t dry from the phone screen, visit a technician to remove the screen and wipe out the water from the display.
If the phone is not turning on after dropping into the water, wipe the water completely from the phone and immerse the smartphone in a container with rice or silica gel packages for 8-10 hours. Then, try to turn on your phone. If it doesn’t work, visit the nearby service center and repair the phone.
To fix the water-damaged phone from not charging, try cleaning the charging port using the required tool on the cleaning kit. Make it dry and charge the phone again.
0 Comments